Lectrosonics Compatibility

[Jonathan]

I know the LM series Lectrosonics transmitters have multiple modes for different receivers.

Will the LM transmitters work with say a Sennheiser G2 receiver on the same frequency? Would it have the correct frequency response,etc...?

I know I used to use a non mic plug that wasn't Lectro with a Lectro receiver back in the day with no problems.

 

[b-roll]

We are using Lectrosonics transmitters with a slot mounted Sennheiser receiver. It works fine as long a the compatibility mode is adjusted on the transmitter itself.

Lectrosonics was great about walking me through the process.

kev

 

[Shootblue]

I have an LM100 for work and so far have been pleased with its performance. I have no doubt that there is a quality difference between it and a 400, in addition to the more obvious differences, but for day to day stuff in a not too intensive RF environment they are good. Handy to know that they can do this as well. Now if I could just get to be pleased with my XDCam audio...

 

[Todio]

Yes lectro trx will work with Sennheiser G2 rx on the same frequency. All you have to do is switch the transmitter to Mode 200. Here is a nifty pdf document on how to do this exactly. http://www.lectrosonics.com/service/tn1024.pdf

 

[Stoney]

How about the opposite, a Sennheiser transmitter to a Lectro receiver?

 

[2000lux]

Now if I could just get to be pleased with my XDCam audio...

What's wrong with your audio?